120 VAC control box with key switch, e-stop, and fire button. Unit will not operate without the key which will give you an extra level of safety. When the key switch is turned on and the e-stop is not activated, power will be sent to your hot surface ignitor (HSI) and/or other acessories, and the fire button will be active. Once you push the fire button you effect solenoid valve will be activeted "poof". If an emergency arises, simply push the big red e-stop button and the electrical power to the effect will turn off. Both the power cord and effect cord can be removed for easy storage. Case is dust and water resistant.
Flame effect control box has the following features:
- 120 VAC
- 10 A
- Dust and water resistant enclosure
- Fused power inlet (10A)
- 6 ft. power input cord (NEMA 5-15P)
- Keyed lockout switch (maintained)
- E-Stop switch (maintained)
- Pushbutton "fire" switch (momentary)
- 20 ft. output cord (16/4)
- Keyed switch enables/disables power to E-Stop, HSI, and pushbutton switch
- E-Stop switch enables/disables power to HSI, and pushbutton switch
- Pushbutton switch enables/disables power to effect solenoid
If you are NOT using an HSI on your effect, the HSI output wiring could be connected to any 120 VAC load, such as lighting.
NOTE: This control box was custom manufactured by Present-Teck Labs. If you need a custom control box other than this model you can reach out to them directly https://www.facebook.com/presentteck/